Thestroj za peskanje s kavljemna splošno ima večji videz, postopek namestitve pa je razmeroma bolj zapleten kot pri majhni opremi. Pravilna namestitev in preizkusni stroj sta ključna za zagotavljanje normalnega delovanja poznejše opreme. V primeru nekvalificiranih začetnih operacij morajo uporabniki dosledno upoštevati navodila ustreznega osebja ali se sklicevati na navodila. Nepooblaščeno delovanje lahko zlahka povzroči nepopravljivo škodostroj za peskanje s kavljem. Theshot blasting machine manufacturer has sorted out the precautions for installation and test machine to share with you. I hope it will be helpful to users who use the device for the first time.
1. Installation. Thestroj za peskanje s kavljem is installed and debugged in the production plant and disassembled into several parts before being transported to the user site for installation. Although there is no pit, the foundation must be firm, the anchor bolt holes must be standardized, and the chamber body must be adjusted. After the second irrigation, the anchor bolt nuts can be tightened after solidification. After the chamber body is fixed, the various parts can be installed. Theprecautions for the installation and debugging of the relevant components are introduced below.
1. Naprava za razstreljevanje:
Theshot blasting device has been installed on the chamber body before leaving the factory. Please pay attention to the problems to be debugged before use. Check whether the fixed positions of the blade, the pill wheel, the directional sleeve, and the guard plate are accurate and firm, and check whether the direction of rotation is correct after power on. Then adjust the position of the directional sleeve opening. Theoretically, the angle between the front edge of the directional opening and the front edge of the blade throwing position is about 900. After fixing the position of the directional sleeve, the position of the projectile belt can be detected by hanging Place a steel plate or wooden board on the position of the workpiece facing the exit of the shot blasting machine, start the shot blasting machine, put a small amount (2-5kg) of projectiles into the blasting tube, and then stop, check whether the hit position on the steel plate is suitable for the needs, such as Close the window of the bias-adjustable directional sleeve downwards, and vice versa, until it fits, and note the position of the directional sleeve opening as a basis for future replacement of the directional sleeve.
2. Dvigalo in vijačni transporter:
Najprej izvedite preskus brez obremenitve, da preverite, ali dvižno vedro in spiralna rezila delujejo v pravi smeri, nato privijte pas dvigala na zmerno stopnjo napetosti, da ne pride do odstopanj, nato pa izvedite preskus obremenitve, da preverite delovanje in transportno zmogljivost, ali obstaja kakšna nenavadnost Hrup in vibracije, preverite in odstranite ovire.
3. Ločevalnik peska:
Najprej preverite, ali je gibanje ovna prožno, nato preverite pravilen položaj ločilne plošče, nato pa, ko je dvigalo obremenjeno in odpravljeno, pride do neprekinjenega dotoka jeklenih strel in preverite, ali jeklene strele odtekajo in padajo ko se žleb izprazni